Hospitality and retail
Food-court strip-out: the counter, kitchen and shared building
A food-court unit connects a tenant's counter and kitchen to a shared shopping centre. Its removal boundary therefore needs more than a list of restaurant fixtures. Establish which interiors belong to the tenant package and which seating, frontage, services and routes remain under centre management.
Planning guidance by MetroPoint Demolition. Illustrative comparisons describe decisions, not completed projects.
Compare an operator change with a reset
For a new operator retaining the kitchen layout, the work may concentrate on branded joinery, selected finishes and fixed counters. A full tenant reset can add internal partitions, ceilings and floor layers. In either case, the incoming design should identify what is useful enough to retain before a blanket strip-out is requested.
| Interface | Question to resolve |
|---|---|
| Counter to public seating | Where does the tenant floor finish stop? |
| Kitchen to shared exhaust | Which contractor owns release and any alteration? |
| Storefront to common ceiling | Which surfaces and building systems remain? |
| Unit to service corridor | What access and loading arrangements does the centre permit? |
Illustrative counter-to-kitchen plan
Consider a unit whose front counter changes while the back cooking area remains in the same arrangement. Mark the counter and floor removals at the front, the retained kitchen boundary behind them and the service corridor beyond. Connected devices passing through the counter still need their providers' attention, even though the kitchen is retained.
If the design instead relocates cooking equipment, revisit the ordinary floor and wall package after the relevant trades establish their requirements. This example is illustrative, not a promise that either operation can continue during construction.
Keep specialist releases visible
Gas, refrigeration, grease, extraction and fire-suppression work are not absorbed into an ordinary fit-out removal. The landlord and appropriate contractors resolve those systems and any shared dependencies before affected work. Removing loose equipment also requires an authorised destination; unclaimed items are not automatically debris.
Define what the new operator receives
Agree the exposed floor, wall and ceiling condition with the fit-out contractor. Distinguish demolition from surface repairs, new services and equipment commissioning. Bring the tenant plan, mall instructions and retained items to MetroPoint so the assessment can follow the actual leased boundary and intended handover.